OneMS Kit

• Used to adjust the implant location or tighten abutment, screw, etc.• Apply torque by pulling bar to the line indicationg the torque value• Applies up to 30Ncm of torque (markers at 10/20/30Ncm)

• Used for correcting path deviation• Can establish implant placement path during surgery• For inclined bone cutting with a flat blade design• For the 13mm specification, depth adjustment follows marking lines: upper line (11.5mm),...

Used as a torque driver to connecting to the engine

Used with the torque wrench for adjustment of the final implant placement

Used with the torque wrench for adjustment of the final implant placement for MS implant narrow ridge

Used to remove gingiva to continue with flapless surgery

Used for narrow or uneven ridges

• Forming a hole in bone to facilitate initial drilling• Bone density can be checked through drilling• Sold as an individual item• Recommended speed : 800~1,200 rpm

Used to remove cortical bone in hard bone

• Optimized straight drill for MS implant / TSIII Ø3.0, KSIII Ø3.0 implant(For placing MS Ø2.0~3.0, TSIII Ø3.0, KSIII Ø3.0 implant)• OneMS Cortical Drill is used for placement of TSIII Ø3.0, and KSIII...

Digital Narrow Ridge Kit

• If the MS implant is jammed in the Driver, the Driver Separator can be levered in to separate the two

Laser markings on drill match implant length specifications: (8/10/11.5/13/15 mm)In cortical bone, it is recommended to use the lance drill to drill to the final implant lengthLong type has a stopper at 13mm

• Tightens Screw Driver and removes the implant using the Remover Body• Applies up to 400Ncm of torque (markers at 80/100/200/300/400Ncm)• Torque by pulling the bar back until it reaches the desired torque value marking• Clean and...