122 Taper Kit

Optimized to taper fixture 2 time drilling sequence fixture placement => reducing chair time Built in stopper helps control drilling depth Good cutting force (excellent drilling power) and low ricocheting Color coded to differentiate drill diameter

• Used to adjust the implant location or tighten abutment, screw, etc.• Apply torque by pulling bar to the line indicationg the torque value• Applies up to 30Ncm of torque (markers at 10/20/30Ncm)

• Parallel pin for 122 Taper Drill• Used for checking position and direction of bone preparation• Lower part for 2.2 drill, upper part for guide drill• 122 Taper Kit single item (excluded from Taper Kit)• Other components same...

• If the MS implant is jammed in the Driver, the Driver Separator can be levered in to separate the two

The drill is used to removing cortical bone at the hard bone (for ultra-wide)Dedicated drill for each implant diameterIt is recommended to drill to the bottom of the marking line

• Taper drill for Type III fixtures• Specification by diameter and length• Color coding displays fixture diameter• One step large-diameter drill is used• to remove cortical bone from the hard bone• 122 Taper Kit single...

• Taper drill for Type III fixtures• Specification by diameter and length• Color coding displays fixture diameter• One step large-diameter drill is used• to remove cortical bone from the hard bone• 122 Taper Kit single...

• Taper drill for Type III fixtures• Specification by diameter and length• Color coding displays fixture diameter• One step large-diameter drill is used• to remove cortical bone from the hard bone• 122 Taper Kit single...

• Taper drill for Type III fixtures• Specification by diameter and length• Color coding displays fixture diameter• One step large-diameter drill is used• to remove cortical bone from the hard bone• 122 Taper Kit single...

• Taper drill for Type III fixtures• Specification by diameter and length• Color coding displays fixture diameter• One step large-diameter drill is used• to remove cortical bone from the hard bone• 122 Taper Kit single...

• Taper drill for Type III fixtures• Specification by diameter and length• Color coding displays fixture diameter• One step large-diameter drill is used• to remove cortical bone from the hard bone• 122 Taper Kit single...

• Taper drill for Type III fixtures• Specification by diameter and length• Color coding displays fixture diameter• One step large-diameter drill is used• to remove cortical bone from the hard bone• 122 Taper Kit single...

Forming a hole to facilitate initial drillingBone density determined through drilling

Used for limited access for the Stopper Drill into the oral cavity

• Releases excessive torque when hand piece does not move due to being stuck in bone during expansion drill removal process.• Use with an open wrench to turn the hex of the Expansion drill • Prevents from over torquing

• Drill Extension

• Connects to mounted implants for placement• For use with a handpiece/implant motor

• Connects directly to an ET implant for final adjustments to the implant's depth• *C = Connection

For 122 Taper Kit/Taper KitLong stopper (6mm): Enabling a procedure without drill extension for posterior regionThe color coded stopper indicates the drill length.

• Drill for marking location of osteotomy to facilitate initial drilling

• Driver for torque wrench• Tip holding function• May bend or break if excessive torque is applied• Damage is possible even at low torque if not fully engaged• Apply vertical pressure when applying torque driver (Do not...

• Manual driver• Tip holding function (except internal hex type)• Internal hex type length: 11mm